Formateur agréé par la Commission des partenaires du marché du travail aux fins de l'application de la Loi favorisant le développement et de compétence de la main d'oeuvre.

CABLE AND WIRE HARNESS IPC/WHMA-A-620 FOR SPECIALIST

 

This 3-day, lectured course is a comprehensive, operator-level certification that teaches inspection and assembly criteria for all three classes of cable and wire harness assembly. 

This course is based on the IPC/WHMA-A-620, “Requirements and Acceptance for Cable and Wire Harness Assemblies”, the most widely used inspection specification for the cable and wire harness assembly industry.

 

OPTIONAL HANDS-ON LABS This is an optional, 1-day, hands-on lab.

COURSE OUTLINE

Day 1

Module 1:

Introduction/Policy and Procedures

Requirements and Acceptance for Cable and Wire      

Harness Assemblies and Applicable Documents

Cable/Wire Preparation

Measuring Cable Assemblies

Testing Cable Assemblies

Review and testing

Module 2:                                       

Crimp Terminations

Insulation Displacement Connections

Review and testing

Module 3:

Soldered Terminations

Review and testing

Day 2

Module 4:

Connectorization Molding/Potting

Review and testing


Module 5:

Splices

Review and testing

Module 6:

Marking and Labeling

Wire Bundle Securing

Shielding

Cable/Wire Harness Protective Coverings

Review and testing

Day 3

Module 7:

Coaxial and Twin axial Assemblies

Review and testing

Module 8:

Solderless Wire Wraps

Review and testing

Day 4 - Optional Hands-0n Labs

Module 1: Lab Overview

Review harness assembly print, materials and tooling

Module 2:

Wire Prep and Solder Termination – no soldering

Cut and semi-stripping five wires

Install wires onto the harness board          

Module 3: Lug Crimp Terminations

Cut, strip and crimp two styles of lug-type terminals

Install wires onto the harness board

Module 4: Pin Crimp Terminations

Cut, strip and crimp two styles of pin terminals

Install wires onto the harness board

Module 5: Coaxial Terminations

Cut, strip RG59 wire; assemble two coaxial connections

Install wires onto the harness board

Module 6: IDC Terminations

Cut, strip CAT5 wire; crimp two IDC connectors

Install wires onto the harness board

Module 7: Mass Terminations

Cut, ribbon cable; crimp two mass termination connectors

Module 8: Harness Securing

Secure the cable using tie-wraps and lacing cord

 

An IPC WHMA-A-620 Certificate will be given to the Student at the end of Training if he or she succeeds.

The IPC Certificate is valid for 2 Years and during that time you can add any modules. TEKTRO Certificate of Training (Lab only)

To download our courses

    Powered by http://www.creation-site-internet.ca/